PRO AV CATALOG
Square One 8 Channel Dynamics Processor
Model: SQ1D
- Provide eight complete channels of either compression or gating, with push button selection
- LED status indication of operational mode on an individual channel basis
- Compressor section on each channel shall provide for adjustment of threshold, make-up gain, attack and release times and ratio
- RMS or Vintage emulation (peak) response and push button selection of soft or hard knee mode on each channel
- Gate section on each channel shall provide for adjustment of threshold, attack, hold and release times and range
- Provide eight complete channels of either compression or gating, with push button selection
- LED status indication of operational mode on an individual channel basis
- Compressor section on each channel shall provide for adjustment of threshold, make-up gain, attack and release times and ratio
- RMS or Vintage emulation (peak) response and push button selection of soft or hard knee mode on each channel
- Gate section on each channel shall provide for adjustment of threshold, attack, hold and release times and range
- Each channel shall have a six-segment input level meter and ten-segment attenuation depth meter, which will show the gain reduction being applied in both compression and gating modes
- Each channel shall have a sidechain band-pass filter with rotary control knob for frequency control and shall be enabled by push button switch
- Band-pass filter shall have two different bandwidth settings, selectable by a push button switch
- There shall be provision for an external sidechain input selected by the external key switch with LED status indication
- Bypass switch shall set the signal path to unity gain on each channel and provide LED status
- Each channel shall have solo switch with LED status indication that sends sidechain signal to solo bus output connector
- Solo bus input connector shall allow multiple dynamics units to be chained together to form a common solo bus output
- Depth: 8 in
- Height: 5.25 in
- Width: 19 in
- Product Weight: 9.70 lbs
- Shipping Weight: 11.90 lbs
- Sampling Rate/Frequency: 20 kHz
- Sampling Rate/Frequency: 20 Hz
- Sampling Rate/Frequency: 0 Ghz
- Input Impedance: 5000 ohm
- Number of Audio Channels: 8
- Output Impedance: 50 ohm
- AC Voltage: 240 Volts
- Active Power: 35 Watt
- Inputs: 8 (mic/line)
- Input Type: Analogue, electronically balanced, female XLRs (Pin 2 hot)
- Maximum Input Level: +22dBu
- Input Impedance: 5 kohms
- Common Mode Rejection: -80dB at 1kHz (typical), unity gain (0dB)
- ratio (CMRR): -100dB at 1kHz (typical), maximum gain (+40dB)
- Outputs: 16(rear panel)
- Operating Level: 0dB
- Maximum Level: +22 dBu
- Output Impedance: <50 ohms
- Signal drive capacity: <600 ohms
- Headphone Output: 1
- Rating: 750 mW (nominal 50ohm load)
- Audio: Front panel connectors
- Channel Input: Eight x AA series female XLRs (labelled "IN 1" to "IN 8")
- Isolated output C: Eight x AA series male XLRs (labelled "TX OUT 1" to "TX OUT 8")
- Electronic output A: Eight x AA series male XLRs (labelled "OUT A")
- Electronic output B: Eight x AA series male XLRs (labelled "OUT B")
- Power: 3-pin IEC
- Frequency Response: ±0.5dB (input to output), 20Hz to 20kHz
- Distortion: <0.02% at 1kHz, 0dBu at unity gain
- Dynamic Range: >122 (electronically balanced outputs) and >140 dB (transformer isolated outputs)
- Noise Floor Unity gain: <-100 dBu
- Mic EIN a5 +40dB gain: <-128 dBu
- High pass filter frequency: -3dB at 30Hz
- Filter slope: 12 dB/Octave
- Number of Inputs: 8
- Number of Outputs: 16
Suggested Products
Advanced Sound & Communication
3817 Broadway
Kansas City, MO 64111
USA
(816) 931-9525
www.advancedsoundkc.com